GUITAR AMPLIFIER
HARDWARE
MACHINE SCREWS KEP NUTS STANDOFFS / SPACERS SOLDER / GROUND LUGS
STAINLESS STEEL PHILLIPS HEAD MACHINE SCREWS
HIGH QUALITY STAINLESS STEEL.
4-40, 6-32 & 8-32 THREAD SIZES AVAILABLE.
4-40 screws are good for mounting 9 pin sockets and other
small parts.
#6 screws are good for octal sockets, some output transformers and for mounting
turret boards.
#8 screws are good for mounting power transformers, output transformers and
other heavier parts.
 |
4-40 thread, 1/4" length.
Pack of 10... $1.75
4-40 thread, 3/8" length.
Pack of 10... $1.75
4-40 thread, 1/2" length.
Pack of 10... $1.75
4-40 thread, 5/8" length.
Pack of 10... $1.75
6-32 thread, 1/4" length.
Pack of 10... $1.75
6-32 thread, 5/8" length.
Pack of 10... $1.75
6-32 thread, 3/4" length.
Pack of 10... $1.75
6-32 thread, 1-1/8" length.
Pack of 10... $1.75
8-32 thread, 1/4" length.
Pack of 10... $1.75
STAINLESS
STEEL KEP NUTS
These have the built in rotating lock washers. No washer needed.
#8 Kep nuts are standard for mounting speakers.
Pack of 10... $1.75
ALUMINUM HEX STANDOFFS WITH HARDWARE
1/4" ALUMINUM
STANDOFF
W/ STAINLESS SCREW AND LOCKING NUT.
These are good for low profile boards like some Fenders.
|
1/2" ALUMINUM STANDOFF
3/4" ALUMINUM STANDOFF
only $1.00
each
W/ BLACK SCREW AND ZINC LOCKING NUT.
W/ STAINLESS SCREW AND LOCKING NUT.
This setup will mount your circuit board up higher for easier access to under
board wires.
 |
These are used for grounding points in your amp. Bolt them down to your
chassis and solder your ground wires right to them.
If you are using a 4/40 screw, use a size 4 ground lug, a 6/32 screw a #6 lug
etc...
#6 lugs come in 2 different styles. Single hole and double hole.
Only... $0.25 each
SOLDER LUGS
CRIMP STYLE
|
|
These can be crimped and soldered for extra
stability.
Only... $0.25 each
FENDER WASHER... $0.25 each
#8 hole. 3/4" diameter.
Perfect for power or output transformer support.
|
|
RUBBER WASHER
Good for shock mounting or isolation. Through hole for 8-32 screw.
.38" OD, .25" high.
|
|
10 for $1